We couldn't input a model's sec/timestep correctly because the calculator doesn't accept the decimal comma. So we had to put a whole number.

**- fixed in 0.2.5**

The HADSM3 calculation is based on the number of timesteps for a single phase. Users would want to enter the current phase number and timestep.

**- wontfix, HADSM3 has only one phase**

The HADSM3-MH calculation is based on the total number of timesteps for all 4 phases. Users would want to enter the current phase number and timestep.

**- added in 0.2.6, note: this is not necessary to set a phase, all phases have the same timestep values, new: added "Current phase" and "Time until phase end", only useful for HADSM3H model**

The calculator treats the BBC and the current HADCM model as one type, but the BBC model is 160 years and the current HADCM from CPDN is 80y.

**- fixed, changed all to 80 in 0.2.6**

- 160 years model added in 0.2.6 (BBC again too, same model)

- 160 years model added in 0.2.6 (BBC again too, same model)

The number of years for a HADCM3 task is embedded in the task name, with an additional 360 TS to reach the point where the final upload file is generated (i.e. the total TS is 25920 * <number_of_years> + 360). The additional 360 timesteps aren't included in the calculation.

**- added in 0.2.6**

The number of years for a HADAM3P task is also embedded in the task name, though with an extra month and an additional 96 TS (i.e. the total TS is 2880 * (12 * <number_of_years> + 1) + 96). The additional 96 timesteps aren't included in the calculation.

**- added in 0.2.6**

Time until phase end with higher s/ts values shows wrong values

**- fixed in 0.2.7**